Huawei H12-211 Daily Practice Exam New 2022 Updated 320 Questions
Use Valid H12-211 Exam - Actual Exam Question & Answer
Evaluating If You're Suitable for the Exam
Even though H12-211 exam does not have any prerequisites, it's highly recommended that applicants are already conversant with basic PC operations and IT technologies. This knowledge will make their certification journey more manageable because most of the exam areas revolve around network infrastructure. Huawei 12-211 targets both theoretical knowledge and technical abilities helping one to demonstrate proficiency in the basics of networking, along with its key connection methods and construction aspects.
Accordingly, the best candidates for this exam are ICT professionals or those with a background in networking such as network administrators, network engineers, and systems administrators. On top of that, students who want to kick off their careers in this field can also make use of this test as a start-up tool.
Requirements
The target audience for this certification exam includes those ICT professionals who are interested in Datacom network technologies. There are no prerequisites that you need to fulfill to pass this test and get the certificate. However, if you learn the basic network concepts, possible connection methods of networks, installation process of Huawei devices, and the ways how to troubleshoot common network faults, it will be easier for you to master the exam topics and pass the H12-211 test.
NEW QUESTION 35
The following subnet mask is the most suitable point to point link
- A. 255.255.255.240
- B. 255.255.255.252
- C. 255.255.255.224
- D. 255.255.255.248
Answer: B
NEW QUESTION 36
Which of the following statements are correct about TTL field in IP packet? (Choose two)
<choice ident="A">
<choice ident="B">
<choice ident="C">
<choice ident="D">
- A. TTL value will be decremented as a packet is passed through the network devices such as hub, LAN switch and router.
- B. The maximum value of TTL is 65535.
- C. Normally, it's impossible for a router to receive a packet whose TTL is zero.
- D. The main purpose of TTL is to prevent IP packets from circulating endlessly in a network which can consume a lot of bandwidth.
Answer: C,D
NEW QUESTION 37
Used to connect the network interface between devices of different types of network cable is ().
- A. Crossover cable
- B. Straight-line networking
- C. woven cable
- D. shielded cable
Answer: B
NEW QUESTION 38
Which area ID is used by OSPFv3 to identify the backbone area
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 39
The Trunk port can allow multiple VLANs to pass, including VLAN4096.
- A. False
- B. True
Answer: A
NEW QUESTION 40
The VRP operating system commands are divided into four levels: access level, monitoring level, configuration level, and management level. Can run various business configuration commands but not Which level of operating file system?
- A. Access level
- B. Monitoring level
- C. Management level
- D. Configuration level
Answer: D
NEW QUESTION 41
After the administrator successfully logs in to the router through Telnet and finds that the IP address of the interface of the router cannot be configured, the possible causes are ().
- A. The Telnet user level is incorrectly configured.
- B. SNMP parameter configuration error
- C. The Telnet terminal software used by the administrator prohibits the corresponding operation.
- D. The authentication mode of the Telnet user is incorrectly configured.
Answer: A
NEW QUESTION 42
In the X.25 network, Quidway Router can serve as the following which type to use?
- A. X.25 packet switching equipment
- B. DCE equipment
- C. PSN equipment
- D. DTE equipment
Answer: A,B,D
NEW QUESTION 43
The network administrator needs to configure static NAT on RTA, in order to allow Host A to communicate with Host C.
Which command is correct?
- A. [RTA-Serial1/0/1]nat static global 192.168.1.1 inside 200.1.1.10
- B. [RTA-Serial1/0/1]nat static global 200.1.1.10 inside 192.168.1.0
- C. [RTA-Serial1/0/1]nat outbound 200.1.1.10
- D. [RTA-Serial1/0/1]nat static global 200.1.1.10 inside 192.168.1.1
Answer: D
NEW QUESTION 44
A serial interface of a Huawei router currently using HDLC needs to assign PPP as the encapsulation protocol.
Which of the following commands is required to be configured at the serial interface view?
- A. enable ppp
- B. link-protocol ppp
- C. address ppp
- D. encapsulation ppp
Answer: B
NEW QUESTION 45
The following figure shows a routing table. When this router receives a packet with a destination IP address of
9.1.1.1, the router forwards the packet based on the route 9.1.0.0/16 because the matched bit number in this route is the largest.
- A. True
- B. False
Answer: A
NEW QUESTION 46
With reference to the following topology and configuration, two routers are connected through a serial cable.
If no Layer 2 protocol is specified, PPP is used by default.
Protocol interconnection
- A. Wrong
- B. Yes
Answer: B
NEW QUESTION 47
Using the ACL matching route entry shown above on the router RTA, which of the following entries will be matched? (Multiple Choice)
- A. 172.16.1.0/24
- B. 172.16.1.1/32
- C. 172.48.0.0/16
- D. 192.17.0.0/24
Answer: B,C
NEW QUESTION 48
All interfaces on a router belong to the same broadcast domain.
- A. False
- B. True
Answer: A
NEW QUESTION 49
Common IGP routing protocols, including
- A. IS-IS
- B. RIP
- C. BGP
- D. OSPF
Answer: A,B,D
NEW QUESTION 50
In the case of Huawei router, the Tracert command uses UDP to encapsulate probe packets.
- A. True
- B. False
Answer: A
Explanation:
Explanation
NEW QUESTION 51
A user logged into a VRP supported device through telnet, but when attempting to configure the device, found that he is unable to use the system-view command to enter the system-view.
What are the possible reasons for this? (Choose two)
- A. The user's telnet software restricts use of this command.
- B. The device's VTY interface only provides permission for some telnet users to run the system-view command.
- C. The user's privilege level is lower than the level associated with the system-view command.
- D. The system-view command privilege level is lower than the level associated with the user.
Answer: B,C
NEW QUESTION 52
What is the priority of the bridge priority in the IEEE 802.1D standard?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 53
Days off saying VDSL is the correct
- A. VDSL only supports symmetric transmission
- B. VDSL supports both symmetric and asymmetric transmission
- C. VDSL supports only non-symmetric transmission
- D. VDSL can only transmit a fixed rate
Answer: B
NEW QUESTION 54
Which of the following protocol is used to transfer e-mail on the Internet?
- A. SMTP
- B. FTP
- C. MSTP
- D. TFTP
Answer: A
NEW QUESTION 55
Telnet is based on the TCP protocol.
- A. True
- B. False
Answer: A
NEW QUESTION 56
Refer to the graphic, after the ping 10.1.1.2 command is executed on R1, LSW1 receives a tagged data frame from VLAN 10 on LSW2.
- A. FALSE
- B. TRUE
Answer: A
NEW QUESTION 57
The router needs to modify the destination IP address in the data packet when forwarding the data packet.
- A. False
- B. True
Answer: A
NEW QUESTION 58
<Huawei>system-view
[Huawei]history-command max-size 20
Refer to the command output. Which statements regarding the shown command are true? (Choose two)
- A. The default value of the history command buffer is 5.
- B. The command should be configured in the user-interface view.
- C. The command is used to adjust the size of the history command buffer.
- D. Once configured, commands totaling up to 20 bytes can be saved in the buffer.
Answer: B,C
NEW QUESTION 59
Refer to the graphic. An administrator has configured OSPF on the two routers, following which he then implements the command silent-interface s0/0/1 on RTA. What effect will this command have on the network?
(Multiple Choice)
- A. The OSPF neighbor relationship will fail between two routers.
- B. The link information advertised by RTB will no longer be maintained in the Link State Database of RTA.
- C. The link information advertised by RTB will be maintained in the Link State Database of RTA.
- D. The configuration will not affect the OSPF neighbor relationship between the two routers.
Answer: A
NEW QUESTION 60
......
Test Engine to Practice H12-211 Test Questions: https://www.itexamsimulator.com/H12-211-brain-dumps.html
H12-211 Real Exam Questions Test Engine Dumps Training With 320 Questions: https://drive.google.com/open?id=137KgGdDOhIK8GMuwQlCgPJ1-Rlyyi57x
