[Jul 27, 2021] 500-220 PDF Dumps is essential on your 500-220 Exam Questions Certain Success!
500-220 PDF Questions - Perfect Prospect To Go With 500-220 Practice Exam
NEW QUESTION 23
What is the role of the Meraki Dashboard as the service provider when using SAML for single sign-on to the Dashboard?
- A. The Dashboard provides user access credentials.
- B. The Dashboard generates the SAML request.
- C. The Dashboard generates the SAML response.
- D. The Dashboard parses the SAML request and authenticates users.
Answer: B
NEW QUESTION 24
Refer to the exhibit.
What does the MX Security Appliance send to determine whether VPN traffic exceeds the configured latency threshold in the VoIP custom performance class?
- A. 100-byte UDP probes every second, through VPN tunnels that are established over the primary WAN link.
- B. 100-byte UDP probes every second, through VPN tunnels that are established over every WAN link.
- C. 1000-byte TCP probes every second, through VPN tunnels that are established over every WAN link.
- D. 1000-byte TCP probes every second, through VPN tunnels that are established over the primary WAN link.
Answer: C
NEW QUESTION 25
Refer to the exhibit.
Which design recommendation should be considered?
- A. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
- B. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
- C. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
- D. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
Answer: D
NEW QUESTION 26
A customer requires a hub-and-spoke Auto VPN deployment with two NAT-mode hubs with dual uplink connections and 50 remote sites with a single uplink connection.
How many tunnels does each hub need to support?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 27
Refer to the exhibit.
Which outcome occurs when logging is set to Enabled?
- A. Inbound flows are sent to a configured syslog server if a syslog server configured for flows.
- B. The hits counter within this section is now enabled.
- C. This firewall rule is now enabled.
- D. Outbound flows are sent to a configured syslog server if a syslog sender is configured for flows.
Answer: A
NEW QUESTION 28
When wireless SSIDs are configured in Dashboard, which setting on the Access Control page affects the ability of a 2.4 GHz only client device from associating to the WLAN for the first time?
- A. Content filtering
- B. Dual band operating with Band Steering
- C. Bridge mode
- D. 802.11r
Answer: B
NEW QUESTION 29
Refer to the exhibit.
The VPN concentrator is experiencing issues. Which action should be taken to ensure a stable environment?
- A. Configure the MX appliance to Routed mode on the Addressing & VLANS page.
- B. Physically disconnect all LAN ports.
- C. Remove the connection from Internet 1.
- D. Add a deny any/any firewall rule to the end of the firewall rules.
Answer: B
NEW QUESTION 30
One thousand concurrent users stream video to their laptops. A 30/70 split between 2.4 GHz and 5 GHz is used.
Based on client count, how many APs (rounded to the nearest whole number) are needed?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 31
Which two primary metrics does Meraki Insight use to calculate the Application Performance Score? (Choose two.)
- A. Maximum Latency
- B. Per-flow Goodput
- C. Application Response Time
- D. Total Bandwidth Usage
- E. Maximum Jitter
Answer: B,C
NEW QUESTION 32
Which order is accurate for a firmware upgrade on MX appliances in a high-availability configuration?
- A. starts on both MX appliances at the same time and then reboots both appliances after traffic on the primary MX appliance ceases
- B. starts on the secondary MX appliance and then occurs on the primary MX appliance
- C. starts on the primary MX appliance and then occurs on the secondary MX appliance
- D. starts on both MX appliances at the same time and then immediately reboots both appliances
Answer: C
NEW QUESTION 33
Refer to the exhibit.
Assuming this MX has established a full tunnel with its VPN peer, how will the MX route the WebEx traffic?
- A. WebEx traffic will prefer WAN 2 as long as it meets the thresholds in the "Conf" performance class.
- B. WebEx traffic will be load-balanced between both active WAN links.
- C. WebEx traffic will prefer WAN 1 as it is the primary uplink.
- D. WebEx traffic will prefer WAN 2 as long as it is up.
Answer: C
NEW QUESTION 34
Refer to the exhibit.
A packet arrives on the VPN concentrator with source IP 10.168.70.3 and destined for IP 10.116.32.4.
What is the next hop for the packet, based on this concentrator routing table?
- A. Not enough detail is available to determine the next hop.
- B. The Auto VPN peer "Store 1532 - appliance" is the next hop.
- C. The packet is stopped.
- D. The concentrator gateway (10.128.124.62) is the next hop.
Answer: A
NEW QUESTION 35
Which Cisco Meraki best practice method preserves complete historical network event logs?
- A. Configuring the preserved event period to unlimited.
- B. Configuring a syslog server for the network.
- C. Configuring the preserved event number to maximize logging.
- D. Configuring Dashboard logging to preserve only certain event types.
Answer: C
NEW QUESTION 36
What occurs when a configuration change is made to an MX network that is bound to a configuration template?
- A. The configuration change in the bound network is combined with the template configuration inside the template.
- B. The configuration change in the bound network overrides the template configuration.
- C. The template configuration overrides the configuration change in the bound network.
- D. The more restrictive configuration is preferred.
Answer: A
Explanation:
Reference:
Managing_Multiple_Networks_with_Configuration_Templates
NEW QUESTION 37
Which three verbs of request are available in the Cisco Meraki API? (Choose three.)
- A. GET
- B. SET
- C. ADD
- D. POST
- E. PUT
- F. PATCH
Answer: A,D,E
Explanation:
Reference:
Cisco_Meraki_Dashboard_API
NEW QUESTION 38
Company iPads are enrolled in Systems Manager without supervision, and profiles are pushed through Systems Manager.
Which outcome occurs when a user attempts to remove the "Meraki Management" profile on an iPad?
- A. The "Meraki Management" profile cannot be removed.
- B. The "Meraki Management" profile is removed. All the profiles that Systems Manager pushed are also removed.
- C. The "Meraki Management" profile is removed and then pushed automatically by Systems Manager.
- D. The "Meraki Management" profile is removed. All the profiles Systems Manager pushed remain.
Answer: B
NEW QUESTION 39
Refer to the exhibit.
What is an advantage of implementing inter-VLAN routing on an MX Security Appliance rather than performing inter-VLAN routing on an MS Series Switch?
- A. The MX appliance performs data encryption for inter-VLAN traffic.
- B. The MX appliance performs AMP for inter-VLAN traffic.
- C. The MX appliance performs content filtering for inter-VLAN traffic.
- D. The MX appliance performs IDS/IPS for inter-VLAN traffic.
Answer: A
NEW QUESTION 40
......
500-220 Exam with Accurate Engineering Cisco Meraki Solutions PDF Questions: https://www.itexamsimulator.com/500-220-brain-dumps.html
True Cisco Exam Extraordinary Practice For the 500-220 Exam: https://drive.google.com/open?id=1qtZ7aZdY0v1z5cPCYl76EDmyWsrG8cFS
